INSTEON 2443-222 User Manual download pdf (Page 5)

Page 5 of 21 2443-222/2443-422/2443-522 - Rev: 1/21/2014 8:28 AM

Installation

1) Write down the INSTEON ID found on the back of the unit (XX.XX.XX)

2) Turn off breaker/fuse and verify that the power is off

3) Disconnect wires from existing switch, fixture or outlet and prep all wires to

be connected to Micro module, with 3/16” (5mm) of bare wire on the ends

4) Connect wires per diagram which corresponds to your installation

Note: sense lines carry very low current (~0.35mA 240V, ~0.17mA for 120V)

5) After ensuring wires are firmly connected and that there is no exposed wire, turn on breaker/fuse

After a few seconds, load will turn on (if wired into switch or fixture) and Micro module LED will turn green

6) Test by tapping Micro module on/off buttons

Load will turn on and off

Micro Module LED will turn green when load is on and red when load is off

7) If installing a single momentary or dual momentary switch

a) Press and hold set button until it beeps

LED will start blinking green

b) Press and hold set button until it beeps a second time

LED will start blinking red

c) Press and hold set button until it beeps a third time

LED will start blinking green

1 2 3 4 5 6 7 8 9 10 ... 20 21

No comments

INSTEON 2443-222 User Manual Page 5