INSTEON 2443-222 User Manual download pdf (Page 8)

Page 8 of 21 2443-222/2443-422/2443-522 - Rev: 1/21/2014 8:28 AM

Single Momentary Switch

Dual Momentary Switch

Adjust Local Settings

Change LED Brightness (or turn it off)

Default = 50% brightness level

1) Press and hold Set button until it beeps

LED will start blinking green

2) Press and hold Set button until it beeps again

LED will start blinking red

3) Press and hold Set button until it beeps a third time

LED will start blinking green

4) Tap Set button once

LED will start double-blinking green

5) Press and hold Set button until it beeps

LED will turn green (at brightness of connected load)

6) Press and hold Micro module on/off buttons to brighten or dim LED to desired brightness

7) Tap Set button

Micro On/Off will double-beep and return to ready mode

Error Blink

Default = enabled

This setting is only adjustable via software or a central controller. Micro module LED will blink red once if one or more

responders do not acknowledge a message and will blink green once if all responders are successful.

Connected load/responders

Single momentary switch

Tap

Press and hold

Double-tap

LED

Switch

On/Off

(ramped)

Brighten/Dim

until release or full-on/off

(dimmable responders only)

On/Off

(instant)

Green/

Red

Connected load/responders

Dual momentary switch

Tap

Press and hold

Double-tap

LED

Top

(ramped)

Brighten

until release or 100%

(dimmable responders only)

(instant)

Green

Bottom

Off

(ramped)

Dim

until release or off

(dimmable responders only)

Off

(instant)

Red

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Comments to this Manuals

No comments

INSTEON 2443-222 User Manual Page 8

Comments to this Manuals